- Handle Slide -

Note: Some bolts may require tapping with a hammer to insert into holes. Do not tighten any bolt securely until everything is assembled loosely as listed in the instructions.

1. Put the handle slide around the bottom of the square tubing on the T-frame with both ends pointing up.

2. Place the bottom of the handles on each side of the slide.

3. Secure handles with the 5/16" x 3" hex bolt.

4. Raise the handles to waist height and tighten the bolt very tightly to hold handles in the desired position.

Note: As you use the Snow Pusher Plus you will discover the most comfortable height for you. If you need to adjust the height, loosen the bolt and move the slide forward to raise the handles or backward to lower them. Then tighten the bolt again. You may have to tap the slide to move it.
5. Make sure everything is together correctly and then tighten all of the bolts.

6. Put a solid object against one end of the axle and use a hammer to tap the hub cap on the other end of the axle.

7. Change the solid object to the other side and tap on the other hub cap.